Details
Engine Rebuild Kit Includes:
- Cylinder Kits (Sleeve/Liner, Piston, Rings, Wrist Pin, Liner Seals)
- Head Gasket Set
- Oil Pan Gasket
- Rod Bearings
- Main Bearing Set
- This kit includes 14.6:1 Ratio Pistons
- Piston Number 125-8869
- Engine Arrangement 138-8549
- deck surface condition prior to liner installation. Anything less than
- perfect condition at these points can lead to cracked flanges on the
- leading cause of liner flange cracking and should be the foremost
- CYLINDER LINERS WILL NOT BE CONSIDERED WITHOUT SUFFICIENT EVIDENCE AS TO
- CYLINDER BLOCK CONDITION.
- protrusion refer to the appropriate OEM service information or the OEM
- block joint repair procedure (SEHS9564-1). All IPD hardened liners are
- coated with a rust preventative during packaging. Each liner must be
- cleaned of this coating and then dried before placing it in the cylinder
- block. The liner should be cleaned with soap, warm water and a bristle
- brush taking extra care at the seal ring groove and filler band groove
- areas. Carefully dry with compressed air after cleaning is complete.
- Afterwards, the liner seal rings can
- be installed on the liner. At this time lubricate the lower cylinder
- the black filler band with clean engine oil and install in the upper
- band groove. At this time the liner must be installed in the cylinder
- block as the black filler band is designed to swell upon contact.
Fitment Guide
Warranty Information
Reliance Power Parts Warranty Policy
The Reliance Power Parts (RPP) warranty policy covers parts and labor necessary to repair a warrantable failure to the functional condition of the application that existed immediately prior to the failure, as detailed below. This warranty applies to direct customers of RPP only and is non-transferable.
Coverage Periods
- New Internal Engine Parts (Ag/Industrial): 1 year from invoice date, unlimited miles/hours
- Engine Overhaul Kits (Heavy-Duty On-Highway): 2 years from invoice date, unlimited miles/hours
- New Engine Accessories: 1 year from invoice date, parts replacement only
- Remanufactured Engine Accessories: 6 months from invoice date, parts replacement only
- Remanufactured Engine & Drivetrain Parts: 6 months from invoice date, parts replacement only
- Drivetrain Parts: 1 year from invoice date, parts replacement only
- Complete Engines & New Long Blocks (Reliance Manufactured): 6 months from invoice date, parts replacement only
- Remanufactured Long/Short Blocks & New Short Blocks (Reliance Manufactured): 90 days from invoice date, parts replacement only
Engine accessories include turbochargers, fuel injectors, hydraulic pumps, engine oil pumps, oil coolers, water pumps, and electrical components.
Manufacturer's Warranty Items
To serve a wider application base, RPP offers lower volume, rare application, and remanufactured parts from a variety of manufacturers. These parts will be noted on your invoice as subject to a "Manufacturer's Warranty" policy and are not covered under this policy. Engines, long blocks, medium blocks, and short blocks produced by any company other than Reliance are solely covered by the manufacturer's warranty. Contact your Reliance representative for details.
Parts & Labor Coverage
- Parts: Covered at current customer pricing using new or remanufactured RPP approved parts
- OEM/Outside Parts: When RPP parts are available, OEM parts will be credited at RPP pricing. Parts not available from RPP will be covered at billed rate with invoice required
- Labor: Offered at RPP's discretion, not to exceed published flat-rate times and maximum regional wholesale hourly labor rate
- Holiday/Overtime Rates: Not covered
What's Not Covered
This warranty does not cover failures resulting from:
- Owner or operator abuse or neglect
- Operation without adequate coolant, fuel, or lubricants
- Over-fueling or over-speeding
- Lack of maintenance of lubricating, coolant, or air intake systems
- Improper storage, starting, warm-up, run-in, or shut-down practices
Coverage does not include:
- Troubleshooting or diagnostic time
- Towing, transport, or down-time
- Rental fees or incidentals
- Delivery charges, travel, meals, or lodging
- Business losses, docking, or harbor charges
Responsibilities
- Installer: Ensure parts are correct for the application and install according to OEM procedures, specifications, and accepted industry standards
- Owner: Operate and maintain equipment as specified in OEM operation and maintenance manuals
How to File a Claim
- RPP must be notified prior to the end of the warranty period
- All warranty repairs must be authorized by RPP technical staff
- Request a Warranty Claim Form for the return of parts
- Return all claimed parts to the indicated location within 30 days of receiving a Return Merchandise Authorization
- Include failed parts, completed Warranty Claim Form, and copies of related work orders or invoices
- Ship parts freight pre-paid in a condition that makes examination possible
- Parts received without a Warranty Claim Form will be returned freight collect
Important Notes
- Professional Installation Required: We strongly recommend installation by a qualified technician to ensure proper break-in and operation
- Keep Your Records: Retain your invoice and service records for warranty claims
- Questions?: If you're unsure about coverage or need assistance, please contact us
The warranties set forth herein are the sole warranties made by RPP regarding its parts. RPP makes no other warranties, expressed or implied, of merchantability or fitness for a particular purpose.
Recently Viewed
Rod Bearing New David Brown AD4/55 .010 K946351 4 Cyl Diesel 1410, 1412, 1490
Waukesha F310DB, Oliver 1750 Out-of-Frame Engine Rebuild Kit
Main Bearing Set
Crankshaft Remachined International 236, D236 10/20 Rods & Mains
Ford 134, 172, 223, 292 Intake & Exhaust Valve Spring (EAA6513A)
Rod Bearings .25mm Fits Mitsubishi, Caterpillar, Perkins S4SD, S4SDT, C3.4T
Valve Cover Gasket (R49865) for John Deere 254 Diesel
Ford 175 Diesel 2.8L OHV L3 Inframe-Engine Rebuild Kit
Cylinder Head (451240), Loaded, Remachined - Allis Chalmers G262
Camshaft
Main Bearing Set
Thermostat
All specifications and numbers are provided for reference only and should be independently verified before use. While we guarantee our parts match their descriptions and accept returns for any discrepancies, we cannot be held liable for installation costs, modifications, or consequential damages. Questions about compatibility? Contact our parts experts at 800-828-6943, sales@dieselcranks.com, or via live chat, Mon-Fri 8am-5pm EST.